Page 1 of 1
My new truck
Posted: Mon May 05, 2008 6:32 pm
by tom84
Hello, finally remembered to pick up my camera, these are a few pic's of my pick up, i picked it up Saturday afternoon, so far I've got it running, un-seized the clutch, and started stripping to see how bad the rust is. hope you like
http://i103.photobucket.com/albums/m125 ... 3Small.jpg
http://i103.photobucket.com/albums/m125 ... 6Small.jpg
http://i103.photobucket.com/albums/m125 ... 6Small.jpg
http://i103.photobucket.com/albums/m125 ... 7Small.jpg
Hope the pics work.
Posted: Mon May 05, 2008 7:27 pm
by ASL642
Hi Tom, great pictures! What a lovely project - it should keep you busy for a while - keep the photos of the progress coming.
Posted: Mon May 05, 2008 7:36 pm
by tom84
will do, i want to get it done asap, because i intend to use it for my work. But i think its going to take a little longer than first thought due to hidden rust. Where would people recommend for panels?
Posted: Mon May 05, 2008 7:45 pm
by Matt
I have had dealings with ESM when I have been getting panels, they stock Hadrian panels which are a pretty good fit compared with some others
Posted: Mon May 05, 2008 7:47 pm
by ASL642
It all depends on where you are. It might work out cheaper to drive to some of the suppliers as some of the parts are heavy and cost a lot in carriage. That is of course if you have other transport!
Posted: Mon May 05, 2008 8:01 pm
by aupickup
also try fairmile restorations he does some good panels and are made in shop so to speak
Posted: Mon May 05, 2008 8:10 pm
by Jay-Minor
nice project
Posted: Mon May 05, 2008 8:21 pm
by tom84
Posted: Mon May 05, 2008 8:33 pm
by RussLCV
Tom 84
Make sure you register it with the Minor LCV Register
www.minorlcvreg.co.uk
Posted: Mon May 05, 2008 8:56 pm
by d_harris
Go with hadrian panels, they are far and away better than the sri-lanken rubbish that I ended up contending with.....
Posted: Mon May 05, 2008 9:01 pm
by tom84
i've been searching and looking on line, and i keep hearing good things about hadrian, and they look reasonably priced. Just got to see what else
i need to replace and then make 1 big order.
Posted: Mon May 05, 2008 9:29 pm
by Matt
Ignore this post
Posted: Mon May 05, 2008 9:58 pm
by bigginger
What post?
a
Posted: Mon May 05, 2008 10:02 pm
by Matt
that one ;)
