Morris Minor Owners Club

Does anyone know how much degree the torsion bar should be adjustet to?? I was told 60 degree but i think that it's to much!!!

Hello Kim,

what are you trying to do. I'm not aware of any angle procedure for the torsion bars?
Basically you adjust the torsion bars to give the ride height you want. If the car is too low by a large amount the suspension arm needs to be taken off the splines and moved around (1 spline gives about 1 1\2" or 38mm difference in ride height) or if less by adjusting the plate at the rear of the torsion bar.

Alec

Hi!

It's my dad who build up his 55. And he wondered if there was any special way to mount the bars!

Hello Kim,

there is a specific measurement when assembling the suspension, but unfortunately I don't know it. I'm sure there will be someone on here though that does. Make sure the bar goes back on the same side as it came off.

Alec

ah ok the measurement is 17 inches from the botom of the large round hole in the inner wing to the centre of the lower link when at rest

Thank you so much!!

You need to try it and see - the car will settle down over the first few days/weeks and then you will almost certainly need to re-adjust.

ah ok the measurement is 17 inches from the botom of the large round hole in the inner wing to the centre of the lower link when at rest

Ah ok - I alway's wondered if there was an official setting!

I use 4 fingers width between the pivot hole in the bottom trunnion (when suspension is on bottom bump stop) and the free end of the torsion bar arm. You can use a lever but I use a jack to raise the torsion bar arm up to mate with the trunnion pivot pin. If using a jack it can jump out so make sure you allow for that!