Page 1 of 1
Computer help required
Posted: Thu Apr 10, 2008 7:45 pm
by 8009STEVE
I can weld, I can spray etc but I can not get my printer to work properly. When I hit the print button, the paper comes half way out before it starts to print and I lose the bottom half of print.
Anybody got any ideas?
Thanks
Steve
Posted: Thu Apr 10, 2008 8:20 pm
by rv8
weld a longer bit of paper on
Posted: Fri Apr 11, 2008 8:03 am
by NZJLY
Is it a new problem or new printer?
If it is a new printer, it may need a new driver. If it is a new problem you may need to reset the default setting on your printer.
John
Posted: Sat Apr 12, 2008 7:16 am
by Alec
Hello Steve,
firstly go to your printer's maintenance page and do a test page. From that use the help section to correct the fault. (Hopefully
)
Alec
Posted: Sat Apr 12, 2008 4:33 pm
by 8009STEVE
Ended up getting a new printer.