Page 1 of 1
rear hub nut size...67 saloon
Posted: Thu Mar 20, 2008 5:59 am
by cheekytrucker
Hi,
I need to replace the rear bearings and seals of my 67 saloon. Can anyone tell me what size of socket I need to remove the hub nut. Also is either driver or passenger side reverse thread, if so which.
Many thanks in advance.
Glenn
Posted: Thu Mar 20, 2008 9:00 am
by IslipMinor
The nut is 1 7/8" AF or I believe 1 1/8" BSW (Whitworth). The RH or offside thread is conventional RH thread and the LH side is a LH thread.
Posted: Thu Mar 20, 2008 9:48 am
by bmcecosse
Unusual to have to renew the rear bearings - they usually last a very long time indeed! Why do you think they need changing?
Posted: Thu Mar 20, 2008 9:50 am
by cheekytrucker
IslipMinor wrote:The nut is 1 7/8" AF or I believe 1 1/8" BSW (Whitworth). The RH or offside thread is conventional RH thread and the LH side is a LH thread.
Many thanks for the help,
Glenn
Posted: Tue Mar 25, 2008 9:13 pm
by cheekytrucker
bmcecosse wrote:Unusual to have to renew the rear bearings - they usually last a very long time indeed! Why do you think they need changing?
rear axle leaking oil badly, have renewed brake shoes twice, simply because axle oil has leaked through the seals.
cheers
G
Posted: Tue Mar 25, 2008 10:23 pm
by bmcecosse
Seals yes - you may need to remove any 'groove' the old seals have cut in the hub to get new seals to work properly. Bearings are usually fine! But check the diff is not overfilled - and check the little breather on top of the diff housing is clear and not blocked.
Posted: Wed Mar 26, 2008 3:56 pm
by cheekytrucker
Many thanks, had not thought of checking the breather.
G
Posted: Wed Mar 26, 2008 4:53 pm
by youngun
Thats usually the reason, you get excess pressure inside the axel body and oil gets forced out wherever it can! Just unscrew the breather and soak it in some petrol then blast it through with an airline
Posted: Wed Mar 26, 2008 10:09 pm
by alex_holden
You may find there is an invisible groove in the surface the oil seal runs on. I didn't believe there was a significant groove on mine but the new seals leaked almost as badly as the old ones. I wound up doing the job all over again, this time adding a piece of thick gasket paper as a spacer between the hub and the seal, so that the seal ran on a 'virgin' section of the axle. That cured the problem.