Page 1 of 1
Posted: Thu Aug 21, 2003 11:26 pm
by Chris Morley
Yes. these are the only two points.
I've always wondered 1) why the original exhausts weren't in two parts and 2) not supported somewhere near the crossmember.
Posted: Fri Aug 22, 2003 1:14 am
by Cam
Mine was fixed under the front of the rear seat (by a strap to the angled section of floor) and again on the boot floor (just behind the rear valance).
Posted: Fri Aug 22, 2003 9:38 am
by 57traveller
Mine are the same Cam, 2 flat strips of thick rubber clamped to pipe and bolted through floor under front seat and boot. Different lengths so don't mix up I did once and the tailpipe was too low.
fittings
Posted: Fri Aug 22, 2003 7:00 pm
by Willie
Andyb1... you will,or should, find the hole for the middle
exhaust strap on the floor close to the rear seat
support upright. There is a shaped washer which goes
underneath to clamp the flexible strap without chafing
through it.