Page 1 of 1
brake adjusters
Posted: Sat Feb 23, 2008 9:09 pm
by aupickup
can someone tell me the size of the front adjusters for 8 inch drums please
Posted: Sat Feb 23, 2008 9:17 pm
by les
What would the size be measured in? They are larger than the rear ones, if that helps!
Posted: Sat Feb 23, 2008 9:42 pm
by aupickup
measured in inches i think across the slot.
Posted: Sat Feb 23, 2008 9:55 pm
by les
If no reply by tomorrow I'll measure one for you. Until then I'd say 3/8''and the rear 5/16''
Posted: Sun Feb 24, 2008 7:23 pm
by bmcecosse
I never realised/knew they were different!
Posted: Sun Feb 24, 2008 7:56 pm
by bigginger
Spooky - I was just about to post asking if they were the same

a
Posted: Sun Feb 24, 2008 8:17 pm
by aupickup
rear 7" drums and front 7" drums are smaller than the later front 8" drums
Posted: Sun Feb 24, 2008 9:27 pm
by les
The measurement for the front is 3/8''
adjusters
Posted: Mon Feb 25, 2008 9:00 am
by Willie
The 8" adjusters are 10mm across the screwdriver slot. The 7" are 7.5mm. If you use the early type with the 8" brakes you will lose 5to 6 clicks of adjustment before the shoes reach the drums and you will only get to use half the lining thickness before you run out of adjustment.
The adjusters are available new. The rears never altered.
Posted: Mon Feb 25, 2008 7:07 pm
by aupickup
thanks for that willie
its just that i ,amged to get a job lot of about 40 adjusters with masks and wondered what they were for front or back or 8" or 7"
seems esm for example are out of stock of these