Halfshaft spline size ?
Posted: Mon Jan 28, 2008 10:27 am
Hi,
Can anyone tell me the spline size on the halfshaft/diff gears ??
Ta
Can anyone tell me the spline size on the halfshaft/diff gears ??
Ta
Morris Minor Owners Club
Promoting the Preservation and Use of the Postwar Morris Minor
https://board.mmoc.org.uk/
Halfshaft spline size ?
Page 1 of 1
Posted: Mon Jan 28, 2008 3:54 pm
Hi Ian I have a half shaft I can check for you which dimension do you need, may be easier to send me a pm.
Posted: Mon Jan 28, 2008 4:22 pm
Hi,
Just after the diameter of the splined bit, and the number of splines.
But if you were feeling brave and could take a photo of it end on, then that could be handy too
Thanks
Just after the diameter of the splined bit, and the number of splines.
But if you were feeling brave and could take a photo of it end on, then that could be handy too
Thanks
Posted: Mon Jan 28, 2008 11:16 pm
PM sent with info as requested.
Posted: Tue Jan 29, 2008 4:14 pm
Why not share it with us all Kevin ? Stuff like that I try to note in my Manual!
Posted: Tue Jan 29, 2008 6:08 pm
Hi Ian I have sent it again to XXXXX and it's not bouncing.
The half shaft has 10 splines and according to my vernier the splined section is 0.983" or 24.93mm (if I am reading the metric correctly as I still work in English) hope this helps.
The half shaft has 10 splines and according to my vernier the splined section is 0.983" or 24.93mm (if I am reading the metric correctly as I still work in English) hope this helps.
Posted: Tue Jan 29, 2008 6:27 pm
Thanks Kevin - duly noted.
Posted: Tue Jan 29, 2008 10:17 pm
Thanks 
Got the email this time, dunno where the other one went - not hiding in me junk or anything !
Um could you scrub me email from the message here please, spambots and all that, ta !
Got the email this time, dunno where the other one went - not hiding in me junk or anything !
Um could you scrub me email from the message here please, spambots and all that, ta !
Posted: Tue Jan 29, 2008 10:21 pm
Dunnit, innit
a
a