Page 1 of 1
Atlas axle
Posted: Sun Jan 13, 2008 3:28 pm
by FrankM83
HI is it possible to fit an Atlas diff to a standard Morris axle? and upgrade the halfshafts? Thanks
Posted: Sun Jan 13, 2008 4:51 pm
by bmcecosse
I have no idea Frank - but I would say it's highly unlikely ! Of course anything is possible - but much easier to use that complete axle and fabricate the necessary mounts - and a special propshaft to connect.
Posted: Mon Jan 14, 2008 2:38 pm
by IslipMinor
Frank,
As BMC says, anything is possible, but grafting a Ford diff into the A-Series casing is a bit on the 'difficult' side - has anyone done it?
What are you wanting to do? Do you need a stronger axle, different ratio etc.?
Upgraded A-Series axle half shafts are available either as a 'toughened' standard pattern, or a really bullet proof version from Peter May (they are expensive at around £150 each).