Page 1 of 1

wheels

Posted: Thu Oct 11, 2007 10:31 am
by haggis
Does anybody know if standard 13" minilte wheels from a mini will fit my moggy.
I have been told they are 4"PCD.
Can anybody help?
Thanks
Haggis

Posted: Thu Oct 11, 2007 10:33 am
by Orkney
bit of a hijack but same subject - anyone know if montego alloys fit?

Posted: Thu Oct 11, 2007 11:25 am
by Onne
Montego are 4,5" PCD I think, and the offset of the mini wheel might not be right

Posted: Thu Oct 11, 2007 12:41 pm
by moggiemadman
Montego wheels dont fit! yes that is correct Minilite wheels are 4''pcd i have a set on my pickup they work a treat! hope that helps John

Posted: Thu Oct 11, 2007 12:56 pm
by Orkney
Montego wheels dont fit!
Oh darn :cry:

Posted: Thu Oct 11, 2007 4:50 pm
by dunketh
Get used to it... nothing seems to fit the s*dding things. :roll:

Mini wheels will do, probably need spacers though.. standard steel wheels arent far away from the suspension legs as it is!

Only decent alternative to standard are MG Midget wheels - or if you have deep, deep pockets - brand new ones from a specialist. :o

Posted: Thu Oct 11, 2007 5:01 pm
by Onne
I have seen some offers for a set of 4 Minilites including tyres for 250 pounds or thereabouts.

Keep an eye out on EBay

Posted: Thu Oct 11, 2007 5:48 pm
by GAS
Montego fit the Marina/Ital.

Posted: Thu Oct 11, 2007 5:57 pm
by Orkney
Montego fit the Marina/Ital.
Urgg and to think turned one down yesterday, was going to remove all teh bits from it but thought any more stuff here and Robert Lewellyn will be appearing with 2 teams and a film crew so had to say no thanks :o

Posted: Thu Oct 11, 2007 9:55 pm
by bmcecosse
Only Marina/Ital VAN is 4.5" PCD. Normal Marina car is 3.75" PCD - hence many Triumph (not Stag) and MGF wheels will fit a Minor that has been fitted with Marina front discs and hubs - and Marina or Dolomite rear axle. So - makes that conversion a whole lot less expensive if you can chase up a set of MGF 15" wheels which are often cheap on ebay. Montego wheels MAY fit - but only if 3.75" PCD.
For normal 4" PCD Minor - Mini Roverlites will fit as far as pcd is concerned - but I don't know about offset (I think others have said ok?) and the standard Mini tyres are v low profile and probably will look daft on a Minor. However - just fit higher profile tyres (say 70) and should be ok although smaller diameter than 145 x 14 x 80 section Minor tyres.