Morris Minor Owners Club

mot booked in for tom at 12
just noticed track rod end moves quite bad.

been in contact with the mini centre he has some anyone know if they fit he said the number was 1072 if that means anything

thanks

ESM/MGM ref number STR136 track rod end runs from 1959 to 1971, so I would only guess that a mini one may fit. Left and right ones are the same. I gather that the thread on the rod is bigger in diameter on the later car. Have you tried your local motor factors? They usually carry stock (Partco/Motofacts etc). Dont forget to reset your 3mm toe in...

my local has 1 and another on order which will hopefully be here tom at 10.30

cutting it fine hey for the 12.00 deadline lol

but i just took the bad one off and now off to get the one they have in stock it only to 1 min to get off.

luckily i remembered i had a ball joint splitter after about 10 wacks and not budging

i asked partco to check the cross refernce but the mini is dif.

there's a mini place near me and they are only £4 each so i was hoping it would fit o well i'll just have to swap this one tonight and then do the other in the morning and get him to set the tracking up for me

Good plan hope you get fixed in time

Left and right ones are the same. I gather that the thread on the rod is bigger in diameter on the later car.

I'm fairly sure it's the other way round - the eary cars had thicker track rod ends.

I can confirm that Mini ones are smaller and don't fit. TRE is pretty basic MOT pre-check - surprised you didn't find them worn long before now !