brake master kit
Posted: Thu May 03, 2007 8:34 pm
i see they do 2 dif sizes for the refurb kit how do you know which ones which?????????
Morris Minor Owners Club
Promoting the Preservation and Use of the Postwar Morris Minor
https://board.mmoc.org.uk/
brake master kit
Page 1 of 1
Posted: Thu May 03, 2007 8:36 pm
The bore size is normally cast onto the side of the master cylinder.
Posted: Thu May 03, 2007 8:37 pm
cheers for that lee
Posted: Fri May 04, 2007 8:37 am
smaller bore for later cars (8" drums) bigger for the early cars
Posted: Fri May 04, 2007 4:14 pm
True enough but never assume. I believe only one size was widely available for some time so it's fair to say there are a few cars out there with wrong size replacements.smaller bore for later cars (8" drums) bigger for the early cars
Posted: Fri May 04, 2007 5:28 pm
Originally then 
Posted: Fri May 04, 2007 8:00 pm
The best way to tell is to remove the piston - you have to do this anyway to fit the new seals.
If you find the bore is rusted, then you've saved the price of a seal kit (although you'll need to put that money towards a new m/c)
When the car was in production, they had different markings on the outside of the casting to show the bore size, however for at least the last 10 years, they just used the same casting for all spares, so you are taking a risk if you rely on the number on the outside.
If you find the bore is rusted, then you've saved the price of a seal kit (although you'll need to put that money towards a new m/c)
When the car was in production, they had different markings on the outside of the casting to show the bore size, however for at least the last 10 years, they just used the same casting for all spares, so you are taking a risk if you rely on the number on the outside.