Page 1 of 1
boot stay
Posted: Sun Apr 08, 2007 9:08 am
by RogerRust
I am fitting a late boot to Sophie with the self latching support.
Can anyone send me a picture of the fitting arrangement on the car end of the support and accurately measure where it fits?
thanks Roger.
Posted: Tue Apr 10, 2007 1:29 pm
by RogerRust
I've bumped this up - still looking for help.
Posted: Wed Apr 11, 2007 11:22 pm
by Roni
Attempt 2 at this. I hope you will be able to see the tape measurements and scale the photo. The fitting is 2" wide. You will notice that the stay is a gas strut. This gave me one handed opening and closing of the boot.
Posted: Thu Apr 12, 2007 7:47 am
by LouiseM
Roger,
If you need the measurement for the original self latching support rather than a gas strut I'll get this for you today as I have the day off and will be spending it 'tinkering' with my car
Louise
Posted: Thu Apr 12, 2007 2:50 pm
by RogerRust
I thought it would just be screwed into the flange for the boot lip. I see now I will have to make a support bracket.
Now I just need to know how far up or down the bracket is from the top of the opening. So that I can position it correctly.
thanks guys
Posted: Thu Apr 12, 2007 6:09 pm
by LouiseM
The bottom edge of the bracket is exactly 15 1/2 inches from the top of the boot board support 'strut' if that helps.
Posted: Thu Apr 12, 2007 10:47 pm
by Roni
I should have made clear that the bracket on mine is the std one for the self latching support. I tried to take the photo from square on so other dimensions can be worked out. This full length bracket is needed as the boot lip flange is too flexy without it.
Posted: Fri Apr 13, 2007 4:58 pm
by RogerRust
Can anyone recommend a suitable gas ram for the minor boot lid?
Posted: Fri Apr 13, 2007 10:18 pm
by Kevin
PM sent