Page 1 of 1
Heater Front and Rear Screens
Posted: Sat Jan 20, 2007 9:20 am
by ugabugchugabug
In a bold move I have fitted both heated front and rear screens to my 1957 car, (it is used every day)
Can anyone answer these queries?
Question 1.
What current do these use and is it advisable to fit relays in the circuit?
Question 2.
Has anyone got a wireing diagram that thay have drawn up as we know these were never factory fitted.
Many thanks
Antony (Ugabugchugabug)

Posted: Sat Jan 20, 2007 3:26 pm
by Onne
Certainly use relays. Also an alternator, as they take a lot of current
Heated Front and Rear Screens
Posted: Sun Jan 21, 2007 12:05 pm
by ugabugchugabug
Onne wrote:Certainly use relays. Also an alternator, as they take a lot of current
Has anyone suggestions of what sort of relays are appropiate?
Many thanks
Posted: Sun Jan 21, 2007 5:02 pm
by simmitc
The rear screen, saloon or traveller draws around 8 - 10 amps and should be used for up to ten minutes. The front screen version that was out a couple of years ago draws 13 amps. The latest (available from the factory since summer 2006, but dealers might have older stock) has a wider heated area and so draws about 0.5 amps more. The front screen is a quick heat and shuold not be used for more than 3 or 4 minutes - but in my experience, 1 or 2 minutes is more than enough.
It is possible to get 12 volt switches that will easily handle 15 amps (eg the headlight switch) but any automotive "accessory" relay from any car parts shop will be suitable - 20 amp, 30 amp, etc. Look for 4 terminals: 1 from the switch, 1 to earth plus a supply and load pair. The relay will come with a wiring diagram.
Basically, for each circuit take a wire from the unfused and unswitched side of the car wiring harnbess through a new fuse (15 amp) and then to the relay supply. From there to one terminal on the screen. The other screen terminal goes to earth. Traveller rear screens should be wired in series. The supply to the switch is taken from the ignition switched ciruit. From the switch to the relay and the last relay rerminal goes to earth.
In operation, when turning on the ignition you supply power to the heated screen switch. When operating the switch you supply power to the relay. This then supplies power to the screen.
Good luck, you'll need them this coming week if the weather forecast is correct.
It is possible
Posted: Sun Jan 21, 2007 5:32 pm
by ugabugchugabug
Hi Simmitc
Many many thanks for the excelent information, just what I needed!
Cheers
Antony
