Page 1 of 1
Servo Plumbing pictures and routing
Posted: Thu May 25, 2006 3:32 pm
by heathy12
Guys. Don't suppose anyone could help with the best place to mount a servo and where best to route it??! Ive got Marina discs up front and 9"drums on the back and a BMC servo purchased on ebay!
Im trying to find the best set up for mounting the servo in the engine bay and having all the pipework running so as to be nice and tidy.
Any pictures would be usefull also as it gets a bit confusing if not tricky explaining what runs where!
Any help or pictures appreciated!
Posted: Thu May 25, 2006 5:08 pm
by aupickup
i have mine on the passenger side inner wing see sig
Servo
Posted: Thu May 25, 2006 8:54 pm
by Willie
Let's see if I can post another pic on here! Mine is on the engine bay floor
on the drivers side as far back as possible.
Posted: Fri May 26, 2006 2:49 am
by NZJLY
I too am looking at adding a servo (with Marina discs). Has anyone replaced the master cylinder with a firewall mounted one? My donor car (celeste) has the servo and master cylinder in one. Thanks.
John
Posted: Fri May 26, 2006 10:36 am
by bmcecosse
Must make access to the starter difficult Willie !
Posted: Fri May 26, 2006 11:21 am
by plastic_orange
access
Posted: Fri May 26, 2006 3:12 pm
by Willie
BMC...no, it doesn't obstruct anything in that position and gives easy access
to the original brake pipes without running across the engine bay.
Posted: Fri May 26, 2006 7:28 pm
by aupickup
hello willie
so how is your servo mounted
Mounting
Posted: Sun May 28, 2006 4:16 pm
by Willie
It is bolted through the engine floorpan and,because I was not happy with the rigidity of the standard mounts I have added an extra metal strap (see pic)which is fixed to the inner wing. Fitting the unit here meant that it cleared
the starter motor and the damper so nothing had to be repositioned.
