Page 1 of 1
Trouble Ahead?
Posted: Thu May 04, 2006 6:27 pm
by Peetee
I was inspecting Joemog for the source of this vibration and have found that the bellhousing has a crack running backwards between the top two bolts that attach it to the engine.
I'm sue it hasn't anything to do with the vibration but has anyone seen this before or would like to predict if I need to do something about it quick?
Posted: Thu May 04, 2006 8:19 pm
by Dominic
I'd be looking for a new gearbox methinks.....
In the meantime I would drill a 1/16" hole at the end of the crack to relieve the stress and stop the crack from lengthening. That is a method used on perspex aircraft canopies.
I remember when I was in a gliding club, a chap had bought a new canopy at great expense. A few weeks later he found a crack, so drilled the ends to stop it running. He then brushed the swarf away... the "crack" brushed away too... a hair! To say that the air was blue was a slght understatement.........
Posted: Thu May 04, 2006 10:31 pm
by bmcecosse
Very unusual PT - never heard of this before. Have heard of backplates cracking - but not bell housings ! Does the crack run into the clearance hole for the rack ?
Posted: Fri May 05, 2006 5:55 am
by Peetee
no mate. at the mo it appears to only run down the vertical section of the mounting flange - about 5mm long.
Posted: Fri May 05, 2006 10:18 am
by bmcecosse
Should be ok - obviously better if you can stop it with a little hole.