Posted: Sat Mar 31, 2007 8:44 pm
Hi all, sorry for not making it, I was a bit under the weather and the the site was down, was it a good evening?
Morris Minor Owners Club
Promoting the Preservation and Use of the Postwar Morris Minor
https://board.mmoc.org.uk/
SADMOG (Sowf'ampton taawn)
Page 38 of 138
Posted: Sat Mar 31, 2007 9:55 pm
You missed me buying a round and getting a complimentary 30 year old malt to boot.
Posted: Sat Mar 31, 2007 10:36 pm
Posted: Sat Mar 31, 2007 10:37 pm
Will be about Brighton tomorow unless it is lashing it down, fingers crossed! 
Posted: Tue Apr 03, 2007 9:48 am
Good to see you again at Brighton, did you find your chips in the end? ;-)
This weeks venue for SADMOG folks?
The evening are drawing out, but probably a little early to be sat outside for the first drink just yet.
This weeks venue for SADMOG folks?
The evening are drawing out, but probably a little early to be sat outside for the first drink just yet.
Posted: Tue Apr 03, 2007 12:00 pm
I have to give apologies for this week - visiting family.
Posted: Tue Apr 03, 2007 4:19 pm
Not been to the Bold for a while. But any better suggestions would be welcome 
Posted: Tue Apr 03, 2007 5:54 pm
If we go to the cricketers I will bring the Trav... i dont want to take it much further than that it will cost too much in oil!
Posted: Tue Apr 03, 2007 10:48 pm
CHIPS did someone mention CHIPS !Rob_Jennings wrote:Good to see you again at Brighton, did you find your chips in the end? ;-)
This weeks venue for SADMOG folks?
The evening are drawing out, but probably a little early to be sat outside for the first drink just yet.
I was so hungry, I did find some cardboard ones along the prom...It was good to see some other SADMOG fanciers there, what a great day too, sun shining. My expert eye for Minor parts
I can't make the next two weeks but maybe in a couple of weeks time:)Posted: Wed Apr 04, 2007 9:07 am
If Mike is not able to join us, and I guess Carlo might be busy with children over the holiday?, we could opt for the cricketers, but do they still have a singer on Thursdays? (I remember our last visit was a little drowned out, its ok if nice enough to sit outside ;-) )
or we could go for the barley corn in hedge end? thats pretty close to your neck of the woods Matt, and if Carlo can make it not too far off the motorway for easy access.
It would be good when ever you can make it Antony, give us a little notice and we will do out best for an easy to get to pub ;-)
or we could go for the barley corn in hedge end? thats pretty close to your neck of the woods Matt, and if Carlo can make it not too far off the motorway for easy access.
It would be good when ever you can make it Antony, give us a little notice and we will do out best for an easy to get to pub ;-)
Posted: Wed Apr 04, 2007 11:35 am
Favour to ask: does anyone have one of those hot air paint strippers I could borrow (you know, the ones that look a bit like a hairdryer.....)
Posted: Wed Apr 04, 2007 11:57 am
hummmm going to attack the trav woodwork by any chance?
I need to buy one of these for later in the summer when I do that job.
I need to buy one of these for later in the summer when I do that job.
Posted: Wed Apr 04, 2007 5:44 pm
I'll be there but Does anyone know what a worn out Carbon thrust bearing sound like?
If not, you may well after Thursday. If my self diagnosis is correct
If not, you may well after Thursday. If my self diagnosis is correct
Posted: Wed Apr 04, 2007 6:54 pm
Nope, Stripping a unit for the Camper.
Trav update: Tried to roll it today and complete failure, gonna have to revert to plan I think....
Trav update: Tried to roll it today and complete failure, gonna have to revert to plan I think....
Posted: Wed Apr 04, 2007 7:51 pm
What failed? The roller or the car bits?
Posted: Wed Apr 04, 2007 8:39 pm
The car was too heavy, and when the roller was flat, the car wasn't over the centre of gravity yet.
So where are we going then?
So where are we going then?
Posted: Wed Apr 04, 2007 9:09 pm
Ok, So no-one has made a Definate call, so Lets make it the Barleycorn in Hedge End
Posted: Wed Apr 04, 2007 10:13 pm
I'll give it a miss AGAIN this week 
. Will try extra hard to make it the following week and if the weather is nice and its not too far then i may bring the soft top out (if it passes the MOT tomorrow!) 
. No promises though as i have oil pressure issues with it at the moment!
. Will try extra hard to make it the following week and if the weather is nice and its not too far then i may bring the soft top out (if it passes the MOT tomorrow!) . No promises though as i have oil pressure issues with it at the moment! Posted: Wed Apr 04, 2007 10:14 pm
Best of luck with it Carlo!!
Posted: Wed Apr 04, 2007 10:24 pm
Thank you! I have only just come in from outside after stripping and rebuilding the carb to cure a petrol leak and then a couple of hours trying to get the wipers to go, gave up and put a new supply in for them! 
They work fine now, but i have yet another single cable going through the bulkhead! I will re-wire it totally when i get the time and a new loom!
I have only just come in from outside after stripping and rebuilding the carb to cure a petrol leak and then a couple of hours trying to get the wipers to go, gave up and put a new supply in for them! They work fine now, but i have yet another single cable going through the bulkhead! I will re-wire it totally when i get the time and a new loom!