Page 3 of 3

Re: Starting problem - please help

Posted: Sat Sep 29, 2012 9:05 pm
by bmcecosse
Well done - so the problem is with the ignition switch. Was anything done to this ? Just run the engine for a while with the temp lead in place - and set up the idle speed - to allow the battery to pick up a charge!

Re: Starting problem - please help

Posted: Sun Sep 30, 2012 8:59 pm
by mike.perry
Check that all wires to the control box are secure,
Check wires to starter solenoid
Check the wiring to the ignition switch
2 white wires to T2
White/Red to T1
Blue/Brown to T3
You will probably have to remove the speedo which is why it is the last check

Re: Starting problem - please help

Posted: Mon Oct 01, 2012 11:31 am
by whyperion
Can you post photo of starter switch / solenoid engine side. ( though it does more appear to be the ign switch wiring )

Re: Starting problem - please help

Posted: Mon Oct 01, 2012 8:12 pm
by tunnyx
here you go[frame]Image[/frame]

Re: Starting problem - please help

Posted: Mon Oct 01, 2012 8:12 pm
by tunnyx
[frame]Image[/frame]

Re: Starting problem - please help

Posted: Mon Oct 01, 2012 8:13 pm
by tunnyx
[frame]Image[/frame]

Re: Starting problem - please help

Posted: Mon Oct 01, 2012 8:13 pm
by tunnyx
[frame]Image[/frame]

Re: Starting problem - please help

Posted: Mon Oct 01, 2012 8:41 pm
by bmcecosse
Which wire goes to the battery??? Should be the one with the brown wire on.........

Re: Starting problem - please help

Posted: Mon Oct 01, 2012 8:58 pm
by MarkyB
cant get hold of any screw in type leads
It's just HT lead, you should be able to buy any length you like off the reel.

Re: Starting problem - please help

Posted: Mon Oct 01, 2012 9:02 pm
by tunnyx
bmcecosse wrote:Which wire goes to the battery??? Should be the one with the brown wire on.........
No, its the other way round - surely he can't have taken them off and put them back on the wrong way round? Could he?

Re: Starting problem - please help

Posted: Mon Oct 01, 2012 9:27 pm
by bmcecosse
Looks like....... :roll:

Re: Starting problem - please help

Posted: Mon Oct 01, 2012 9:40 pm
by tunnyx
You guys are superb - thanks a lot - running like a dream!!!

I've slapped him around a bit and told him to take photos before he pulls things apart in the future!

Mark

Re: Starting problem - please help

Posted: Mon Oct 01, 2012 10:29 pm
by bmcecosse
Hahahahahahahahahahahahahahahahahahahahah :lol: :roll:

Re: Starting problem - please help

Posted: Mon Oct 01, 2012 10:48 pm
by mike.perry
One of those jobs where an experienced person could look under the bonnet and spot the problem in 2 minutes

Re: Starting problem - please help

Posted: Mon Oct 01, 2012 10:55 pm
by tunnyx
Once again, thanks to everyone who's inputted - I feel darn stupid now, but Jack's owned up - he said he disconnected it when he was replacing the heater pipes and when he put it back together it seemed wrong to 'cross the wires'. In all reasonableness I can't fault his logic!

Cheers y'all - onto the next task now.....

Re: Starting problem - please help

Posted: Tue Oct 02, 2012 9:21 am
by whyperion
I think the logic to remember is the brown wire mounted on the starter switch needs to be attached to the feed from the battery , to take power route power to various loads on the car, (? all loads as I cannot think of any other connection other than the switch itself for starter motor feed ).