Re: 12g940 head on 1098 questions
Posted: Tue Mar 21, 2017 11:01 pm
Sounds about right for what I want. I have the small valve head though which is what was recommended was the one to go for. I think I've read somewhere the small valve has a bit more pulling power and mid range power were as the big valve is all top end.dalebrignall wrote:i had this done in 2 stages i had the induction kit fitted 1st going through standard 1098 head it was too much for it the engine was restricted by the small valves .i then had the maniflow exhaust manifold and exhaust system and a reworked 1275 mg metro head fitted . the engine is a recon 1098 its on plus 20s . the results are very good . its not the power of a 1275 but it wont be far off.. i tend to cruise at 60 on the motorway but if you want to pass a lorry you can with confidance and there is a lot more power going up hills .its still on standard cam but the rockers have been upgraded to forged ones that give slightly more lift im happy with what i have now , but i will stress you need the bigger valves and exhaust system for it to work hope this helps
