Morris Minor Owners Club

Looks like you have a Marina/Ital commercial set up here which is not 3.75".
The Marina stub axle can be made to fit the Minor swivel pin , which will then accept the std Marina bearings etc. The machining cost is about £120 plus vat.
The stud pattern you have is suitable for Toyota wheels, unless you are able to replace them with std car hubs or re drill the PCD
to 3.75".
Hope this helps

thanx guys,thats a big help,now i need to get rid of these mg wheels!! will all that i have fit to my moggie?

The front end will if you undertake the machining. The rear will fit the std Minor springs if you buy the correct axle perches.

Yes - they are Marina van so 4.5" PCD. Good news is - MGB is 4.5" - so plenty of wheels around that will fit.