Posted: Fri Feb 06, 2004 3:15 pm
Hello all,
just a quick note regarding machining the 1098 block. As I am fortunate eough to have a lathe at home I made up a mandrel to fit a small diameter grindstone. Using this and the head as a jig I ground the pockets using a standard power drill to drive the grindstone. This worked quite well, albeit a little slow as the stone was a fine grade one.
Alec
just a quick note regarding machining the 1098 block. As I am fortunate eough to have a lathe at home I made up a mandrel to fit a small diameter grindstone. Using this and the head as a jig I ground the pockets using a standard power drill to drive the grindstone. This worked quite well, albeit a little slow as the stone was a fine grade one.
Alec