Can anyone know where I can source the push in lampholders for the smiths gauges.
I have bought 3 gauges from ebay and none have arrived with the lamp holders, is the lampholder part of the wiring loom.
I had an idea and tried high intensity LED's but the are directional and dont give a good result.
any suggestions?
place for gauges
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
I have a feeling the holder is part of the loom.
However, that means there should be plenty around on old frayed/ melted looms so you can just snip off and splice in
Or alternately, http://www.autosparks.co.uk/store/catal ... t.asp?l=68 - Just under halfway down the page, a variey of holders. I've used Autosparks in the past for a small order, and even though there can't have been much profit in it they were very helpful on the ohne, and the bits turned up very quickly too
However, that means there should be plenty around on old frayed/ melted looms so you can just snip off and splice in
Or alternately, http://www.autosparks.co.uk/store/catal ... t.asp?l=68 - Just under halfway down the page, a variey of holders. I've used Autosparks in the past for a small order, and even though there can't have been much profit in it they were very helpful on the ohne, and the bits turned up very quickly too