Hello again. Me with my 1275 Midget engine, MG Metro inlet manifold, lcb exhaust and a possibly non standard cam.
I wish to replace the float valve and seat, as the valve is worn. The carb has the 7/16 threaded seat.
Should I replace the 70 thou valve and seat with a 96 thou, or stick to 70 thou? I can find no information about this online, try as I might.
Thanks all.
HIF 44 Float Valve Size
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
- Mr Spigot
- Minor Fan
- Posts: 227
- Joined: Mon Sep 13, 2021 2:44 pm
- Location: East Sussex
- MMOC Member: Yes
Re: HIF 44 Float Valve Size
As far as I am aware, the standard size for the HIF44 is 0.096". I have a similar setup but with standard cam and the larger size works very well.
https://www.minispares.com/product/classic/WZX1095.aspx
https://www.minispares.com/product/classic/WZX1095.aspx
1960 2 door with 1275 Midget engine - WOI 577 - owned since 1990
1952 MM convertible with original engine - MWD 305 - owned since 2023
1952 MM convertible with original engine - MWD 305 - owned since 2023
-
- Minor Maniac
- Posts: 11295
- Joined: Thu Jul 19, 2012 12:05 pm
- Location: Hampshire
- MMOC Member: Yes
Re: HIF 44 Float Valve Size
The 0.096" needle and seating (Pt No: WZX1095) is only used on the turbo equipped engine. Needle and seating (Pt No:WZX1099X) is used for non turbo applications.
If you do not have a turbo fitted and you have not experienced fuel delivery problems I would advise that you stick with the 0.070" needle and seating. With the larger needle and seating you may experience over delivery of fuel to the float chamber which may result in a rich mixture.
If you do not have a turbo fitted and you have not experienced fuel delivery problems I would advise that you stick with the 0.070" needle and seating. With the larger needle and seating you may experience over delivery of fuel to the float chamber which may result in a rich mixture.
Re: HIF 44 Float Valve Size
Thank you both. I sort of thought that over richening(?) might possibly be a problem with the bigger valve, but then I was also worried that the smaller valve might not give the flow.
I'm obviously a glass half empty kind of fellow!
I'd ordered a 0.070" anyway, because that's what was in there originally.
I'm obviously a glass half empty kind of fellow!
I'd ordered a 0.070" anyway, because that's what was in there originally.