Non standard

[Dougie212]

So.. I seem to be back and forth on here with one problem then another…

In another post I asked about a non standard cylinder head bolt/stud/bodge…..

Now… while I’m working out reassembling, I’m thinking that the throttle cable bracket, which isn’t attached to the manifold on my car - may have been another bodge…

Pic attached - but just looking for someone to confirm my suspicions.

I’ve tried looking for the bracket and ESM seem to be out of stock. If it is a bodge, I’d quite like to put back together with the proper bracket.

IMG_4411.jpeg (606.5 KiB) Viewed 3836 times

Thanks is advance!!

[philthehill]

Right bracket - wrong stud.
The bracket needs to be move to the next stud forward and the swivel fitted to the side of the bracket giving the best alignment.

[Dougie212]

Brilliant!!!! Thank you Phil

[Classiccars]

Damn good isn't he.

[Dougie212]

Hi all..

Just after some more help from this thread I created. I’ve added a pic below.. can I just confirm that the throttle cable bracket I have needs moving forward to the stud with the red arrow please?

I’ve not properly tried but it just seems like it’ll be a tight fit - but I totally get why it should be there if that’s the case because the path of the cable suggests that’s where it should be.

Advice as always greatly appreciated

IMG_4613.jpeg (769.02 KiB) Viewed 1006 times

[philthehill]

Now that you have shown a full photo of the carb and manifold I can see that you need the accelerator cable bracket that fits between the HS2 carb mounting flange and the manifold. The mount bracket is Pt No: 12A353.
The mount bracket is similar to that in the link below.
https://www.ebay.co.uk/itm/226353309028 ... T8896C9WVQ

Your accelerator cable needs to be replaced and the fuel pump mount bolt tightened.

[Dougie212]

Thanks Phil!!

It’s an old pic. Ive got a new accelerator cable ready to fit.

Do I still require the bracket on the manifold stud too? Or will the bracket in the link replace that??

Thanks as always!!

[philthehill]

The bracket in the link is all that is required with new gaskets of course.
The original bracket can be discarded.

[PhilAllen]

Hi,
My car (late 1969) appears to have the same carb as yours with the engine breather hose connection (top right of your photo). Here’s a photo of the bracket Phil provided the link to so you can see how it fits. I tucked the breather hose out of the way so you can see it more clearly.
Hope it helps,
Phil (a different one!)

IMG_0336.jpeg (1.05 MiB) Viewed 905 times

[Dougie212]

Brilliant!!! Thank you both Phil’s!!! Really appreciate it!!! I’ll get ordering a bracket now.