I'm about to install new Hardura in my '68 Traveller. Material came from ESM, I believe Newton Commercial.
The wheel arch pieces look far thicker than the old stuff I removed. To get them to go down smooth without leaving wrinkles, I think I'll need to glue them down using contact adhesive. I can't tell if the original was glued or not. Anyone have an idea?
I think the flat area is held down well enough with the aluminum strips and screws around the edges, don't think glue is necessary there, or perhaps it does?
Thanks for any advice.
Traveller Load Bay
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Friendly
- Posts: 59
- Joined: Tue Mar 08, 2005 5:31 pm
- Location: Wiltshire
- MMOC Member: Yes
Re: Traveller Load Bay
I had to use glue on the wheel arches but not necessary on the floor. Still all there after 30 years.
- ndevans
- Minor Legend
- Posts: 1088
- Joined: Fri Mar 03, 2006 11:56 am
- Location: Bristol, England
- MMOC Member: Yes
Re: Traveller Load Bay
Yes, same here, contact adhesive on the wheel arches, but the aluminium strips hold the floor area down well enough. It's quite tricky getting the wheel arch strips to lie flat, mine still aren't quite right, but pass a casual glance well enough.
I've also got two extra aluminium strips in my boot floor. Could never understand why, until my dad admitted to putting them in himself!
I've also got two extra aluminium strips in my boot floor. Could never understand why, until my dad admitted to putting them in himself!
-
- Minor Friendly
- Posts: 83
- Joined: Sun Aug 19, 2018 10:19 pm
- Location: Central Texas, USA
- MMOC Member: No
Re: Traveller Load Bay
Thanks for the replies!
As contact adhesive is unforgiving, with only one chance to get it positioned right, I've thought a bit more about this.
The sewed seam on the wheel arch pieces is quite thick, and I realized it's important to have it lying flat in only one direction so that from the top, the seam stitches are hidden underneath. The other way, the stiches will face up and will collect dirt. So I've bought a seam roller like you'd use for wallpaper, and intend to glue the inside of the seam first, forcing it to lie flat in only one direction. When that's dry, I'll glue the top surface of the arch first, let that dry, then glue the vertical wall pulling it down hard as I go.
Well, that's the plan anyway!
As contact adhesive is unforgiving, with only one chance to get it positioned right, I've thought a bit more about this.
The sewed seam on the wheel arch pieces is quite thick, and I realized it's important to have it lying flat in only one direction so that from the top, the seam stitches are hidden underneath. The other way, the stiches will face up and will collect dirt. So I've bought a seam roller like you'd use for wallpaper, and intend to glue the inside of the seam first, forcing it to lie flat in only one direction. When that's dry, I'll glue the top surface of the arch first, let that dry, then glue the vertical wall pulling it down hard as I go.
Well, that's the plan anyway!