What is the brake pipe length

[Sandun]

Hi friends

Can you tell me standard length of two brake pipe , left and right side pipes (from rear joint to brake cylinder of wheel )

I buy the couple , one of them 23 inch , other one 30 inch ( buy from here , they sell that size for morris )

And can you tell me where the correct position to set joint

Regards
Sandun

[kennatt]

not sure of actual size but usual to just take old bits off and measure them then add two or three inches to be sure they will reach,or use a length of string etc, you get rid of the excess buy simple putting a S bend in the middle, or slightly different route dosent have to be straight so long as its secure. Unless of course you are wanting concourse show winning rebuild good luck

[philthehill]

The 'T' connector that that joins the two pipes on either side of the rear axle is attached to the L/H side of the diff housing. There is a hole drilled in the diff housing strengthening flange to accept the 'T' connector.

[Sandun]

Thank you ,

The ''T '' joint had set on a side nut of diff , and bend the pipe around the diff.

i got two brake cylinder too, it has rubber boot , can you tell me , 1st i want to remove rubber boot from cylinder?

[les]

The rubber boot is removed and then fitted to the back of the backplate, after the cylinder has been fitted.

[Sandun]

Thank you ....