I picked up the mower last Saturday and it came with a manual and a full set of gaskets

I mowed the lawn with it and although it ran, it did cut out occasionally and wouldn't idle smoothly so it had to be rebuilt!
I finished the engine on Wednesday. I disassembled it, cleaned and decoked everything fully, repainted it, rebuilt the carb, honed the bore and fitted new rings, lapped in the valves and put it all back together with new gaskets. It's now running better than it was and I know that the engine itself is in top condition.
It's still not right though, it's hunting at idle, doesn't rev smoothly and cuts out occasionally. I've identified one problem as a flooding carburettor so I need to order a new float. I did notice that the needle was slightly bent but I decided to test it first before replacing it. I haven't had a good look at the ignition system yet either. Once I've sorted those bit out the engine should run perfectly (fingers crossed) and I can move onto refurbishing the rest of it
here are some pictures of the mower and the rebuild.[frame]

[/frame][frame]

[/frame][frame]

[/frame][frame]

[/frame][frame]

[/frame][frame]

[/frame][frame]

[/frame][frame]

[/frame][frame]

[/frame]