how do the skuttles / panels fit on,

Post by **Celia** » Sun May 31, 2015 11:06 am

The skuttles I just took off had one screw ito one corner holding it in place, how should they be fitted? are there any illustrations available?

Post by **aupickup** » Sun May 31, 2015 11:26 am

well originally the vinyl had an overhank where the door seal fits over it and holds it in place
the the crash bar held it also in place
they were not screwed on originally

Post by **ManyMinors** » Sun May 31, 2015 5:17 pm

It depends on the age of the car. Originally they WERE screwed and were not vinyl covered but made of millboard coloured to suit the interior. Sometime (early 1960s?) they became covered in vinyl and were held on by the extra material going underneath the draught excluder as stated above.

Post by **aupickup** » Sun May 31, 2015 7:06 pm

yes sorry forgot to mention the way i described was on later cars

Post by **Celia** » Sun May 31, 2015 10:08 pm

Thank you, Celia is a 1959 two door saloon, she had a duo tone interior fitted at some point, but the interior panels are all buckled. I am attempting to straighten the rear panels and have bought new for the front. I might try stick on velcro, that way they will be held by all the edges.

Morris Minor Owners Club

how do the skuttles / panels fit on,

how do the skuttles / panels fit on,

Re: how do the skuttles / panels fit on,

Re: how do the skuttles / panels fit on,

Re: how do the skuttles / panels fit on,

Re: how do the skuttles / panels fit on,