Bushes and stuff

[bmcecosse]

As before - you need to unload the T bar at the front - then take the bolt out (easier said than done...) that goes through the multi hole bracket and the crossmember - move the multihole plate along so a different height hole (up or down as you wish) lines up with the crossmember slot - refit the bolt - reload the T bar. But if you are in-between 'splines' at the front it's the only way to get the heights equal.

[cheezy_munkey]

Think I got it. I'll have a look tomorrow if the weather's ok. Thanks. I'll let you know how it goes.

[David W.]

1/4 inch per hole in the rear bracket. Don't forget the washer between the torsion bar lever and the bracket.

[bmcecosse]

Washer?? What does that do??

[taupe]

The washer stops the arm being misaligned by giving the correct spacing! part No AJD 7162 these are about 1/8" thick from memory.

Taupe

[bmcecosse]

No washer on mine....it seemed quite happy without.....I won't sleep at night worrying about that one now.....

[cheezy_munkey]

Aye, there was a washer on mine. Put it back using it. Finally managed to sort it to a height I'm happy with yesterday. Got it with the nearside slightly lower again but I believe that's recommended anyway. It's the smoothest ride it's ever been since I bought the car and no juddering at all when braking. That'll do me (until the next issue).

Cheers again everyone (particularly Roy). You've been great.

Cheers
Paul.