Steering arm
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
Bonkie
- Minor Friendly
- Posts: 37
- Joined: Mon Nov 21, 2011 11:32 pm
- Location: London chingford
- MMOC Member: No
Steering arm
Need help the track end rod will not pop out of the steering arm any tips
-
GreenGiant57
- Minor Addict
- Posts: 628
- Joined: Wed Apr 11, 2007 10:39 pm
- Location: Chippenham Wiltshire
- MMOC Member: Yes
Re: Steering arm
I got over that by supporting the car underneath the box section to remove the wheel, & then loosen off the track rod locking nuts on the steering rack before attempting to remove track rod tapers from their locations. To remove tapers, loosen the bottom nut & washer a couple of threads, position a jack beneath the bottom of the thread below the taper & jack up the complete assembly so that it is just clear of the rebound pad. Carefully give the top face of the link to the stub axle assembly a couple of good clouts with a hammer and with luck and a following wind the taper should release.
-
Trickydicky
- Minor Legend
- Posts: 1565
- Joined: Fri Aug 05, 2011 9:53 pm
- Location: Leeds, West Yorkshire
- MMOC Member: No
Re: Steering arm
I have one of these and it makes the job so much easier. You may only use this splitter once in a while but it will save you a lot of grief.
Richard
Opinions are like people,everyone can be different.
Opinions are like people,everyone can be different.
