Half-shaft measurements please

Discuss mechanical problems here.
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
Post Reply
Dominic
Minor Addict
Posts: 640
Joined: Tue Dec 27, 2005 4:50 pm
Location: North West
MMOC Member: No

Half-shaft measurements please

Post by Dominic »

Hi,
Does anyone have a half-shaft handy to measure? I need the exact overall length so I can determine if I can get away with removing them while the car is in the (fairly small) garage. Thanks! Dom.
Top
mike.perry
Series MM Registrar
Posts: 10183
Joined: Sun Jul 24, 2005 11:39 pm
Location: Reading
MMOC Member: No

Re: Half-shaft measurements please

Post by mike.perry »

26.5 in
[sig]3580[/sig]
Top
Dominic
Minor Addict
Posts: 640
Joined: Tue Dec 27, 2005 4:50 pm
Location: North West
MMOC Member: No

Re: Half-shaft measurements please

Post by Dominic »

Thanks for that Mike, much appreciated!
Top
Dominic
Minor Addict
Posts: 640
Joined: Tue Dec 27, 2005 4:50 pm
Location: North West
MMOC Member: No

Re: Half-shaft measurements please

Post by Dominic »

Hmmm... if only Issigonis had left the width the same as on the prototype, I'd have got away with removing the shafts in the garage without having to roll it outside to fit new oil seals to the hubs!
Top
bmcecosse
Minor Maniac
Posts: 46561
Joined: Wed Feb 16, 2005 11:24 pm
Location: ML9
MMOC Member: No

Re: Half-shaft measurements please

Post by bmcecosse »

Just do pone side at a time..... Simples!
ImageImage
Image
Top
Post Reply

Return to “Mechanical”