temp gauge wiring

[moggiethouable]

Almost there, but puzzled by the "attach the cable from the temperature gauge to the light green wire".
My photo shows a veritable platoon of green wires, all mid green.
Can anyone point me towards which one please?[frame][/frame]

[bmcecosse]

The single wire going to the fuel gauge should be a 'lighter' green......

[moggiethouable]

The single wire going to the fuel gauge should be a 'lighter' green......

Thank you I shall take a peek.

[moggiethouable]

The single wire going to the fuel gauge should be a 'lighter' green......

I Did get to look at this this morning.
I have a green and red cable and a mid green cable to the fuel gauge,(after I had wiped the dust gathered over 47 years off anyway) I attached the gauge cable to the striped item and got full reading from a cold engine,so I tried attaching to the mid green cable from the fuel gauge and the cold engine read about 70 degrees
The good news is the oil pressure gauge reads around 4 bar at 55 mph and 2 bar at idle, so that was a success I think and probably a lot more use than a temp gauge anyway.
I shall attempt again next weekend the wiring of the temp gauge as the missus quite rightly decided we should have a run out in the Morris, instead of me just "tinkering" so we took the Stokesley to Helmsley rd,probably one of Englands finest for touring and hairiest for motorcyclists.

[PSL184]

On your picture above the green wire with the black connector sleeve is the one you need to piggy back to the temp gauge.

[moggiethouable]

On your picture above the green wire with the black connector sleeve is the one you need to piggy back to the temp gauge.

Thanks for that, I shall try it when the all too brief dry weather we had today returns, appreciated.