Fulcrum pin

Discuss mechanical problems here.
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
Post Reply
stag36587
Minor Legend
Posts: 1395
Joined: Sat Jan 06, 2007 3:55 pm
Location: Raunds, Northamptonshire
MMOC Member: No

Fulcrum pin

Post by stag36587 »

I've just ordered a new lower fulcrum pin from ESM and notice that one thread end seems slightly longer - maybe 5mm - than the other - is this normal? If so, does longer end go at front or rear when looking at the lower trunnion? Also, please can someone confirm right thread for the corresponding nuts?

Many thanks
]
Top
mike.perry
Series MM Registrar
Posts: 10183
Joined: Sun Jul 24, 2005 11:39 pm
Location: Reading
MMOC Member: No

Re: Fulcrum pin

Post by mike.perry »

Long bit to the rear. Should be supplied with nuts and washers
[sig]3580[/sig]
Top
stag36587
Minor Legend
Posts: 1395
Joined: Sat Jan 06, 2007 3:55 pm
Location: Raunds, Northamptonshire
MMOC Member: No

Re: Fulcrum pin

Post by stag36587 »

Thanks, strangely enough nuts and washers were not included.
]
Top
simmitc
Moderator
Moderator
Posts: 4921
Joined: Thu Apr 15, 2004 9:43 am
Location: Essex
MMOC Member: Yes

Re: Fulcrum pin

Post by simmitc »

Thread 5/16 but I've seen both UNF and UNC variants!
Top
Post Reply

Return to “Mechanical”