Hello there,
I set out yesterday to investigate a water leak which I'd assumed was from the radiator but it turns out that the end of the thermostat cover which joins the hose from the radiator has corroded and turned into a crumbly mess. I've got a new cover but the old one isn't budging. So far I've tried tapping with a hammer to try and free up the bolts, given it several soakings of WD40 and similar and even tried to pry it with a flathead screwdriver (Result - the end of the screwdriver snapped and is wedged in the gasket ).... Any tips would be much appreciated!
If the housing is scrap - and it certainly sounds like it... Simply run a hacksaw through it a few times next to the studs but be carefull not to cut through to the cylinder head
Smash the old one with a chisel and heavy hammer. Fit new studs if in any doubt. It's a good idea to run a drill bit down the stud holes in the new cover - easing the holes out slightly - and smear copper slip (or even just grease) on the studs when fitting the new cover.
As Mike says try and avoid damaging the studs - run the saw blade down either side of the stud, if possible just away from them.
The remains of the housing should just fall away as they usually seize around the studs with corrosion.
New studs are simply screwed in but you need to go carefully when you remove the old studs - unscrew them a bit at a time and if theyre stiff, then screw them back in a little and unscrew again with some plus gas- repeat until they free up.
When you fit the new housing a smear of copper grease on the studs will help them to free up when you next have to do it!
Try a brass housing, I never have any trouble with corrosion since fitting one.
Minor developments used to sell them.
It's been mentioned before but don't know if they are still available.
Thanks all for the tips and advice, the pesky cover is now removed thanks to a little bit of cutting next to the studs with a dremmel combined with prying it up with a heavy duty flat-head screwdriver, studs are intact and no damage done to the cylinder head
A good tip if you replace the studs is to put some thread sealant or hylomar on before screwing them into the head - this reduces the tendancy for fluid to leak up between the studs and housing which is the cause of the corrosion.
Not all of them, the new one I had was corroding badly in less than a year snd that was with Bluecol antifreeze. It also seized up on the studs.....
That's quite worrying!! One of the main reasons to use antifreeze all year round is to stop that kind of thing
You should only expect to see a seriously corroded or crumbled thermostat housing if the car has been run without a decent antifreeze dose.
Ray. MMOC#47368. Forum moderator.
Jan 06: The Minor SII Africa adventure: http://www.minor-detour.com
Oct 06: back from Dresden with my Trabant 601 Kombi
Jan 07: back from a month thru North Africa (via Timbuktu) in a S3 Landy
June 07 - back from Zwickau Trabi Treffen
Aug 07 & Aug 08 - back from the Lands End to Orkney in 71 pickup
Sept 2010 - finally gave up breaking down in a SII Landy...
where to break down next?
2013... managed to seize my 1275 just by driving it round the block
Yes, it may have been a 'bad batch' as it didn't have the same smooth appearance or quality of old stock. Corrosion took the form of a sort of white effervesence and pitting to the surface. This was a few years ago so I think 'new' new ones are probably OK as nobody else has reported this since.
).... Any tips would be much appreciated!
