starter handle
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Legend
- Posts: 1182
- Joined: Wed Aug 12, 2009 7:38 pm
- MMOC Member: Yes
starter handle
lastnight the moggy ran out of electricity, so out with the starter handle to breath some life back into it.
ignition on, out of gear, cranked the engine over and over and over and over, yet not a cough, splutter or vague indication of fireing.
i have tried a few times before when the car did have electricty, but the same lack of starting was also observed.
so, why wont my moggy start on the handle?
n.b, i have managed it successfuly on my landrover, 2 wolseleys and austin, so i think i have the knack for it
ignition on, out of gear, cranked the engine over and over and over and over, yet not a cough, splutter or vague indication of fireing.
i have tried a few times before when the car did have electricty, but the same lack of starting was also observed.
so, why wont my moggy start on the handle?
n.b, i have managed it successfuly on my landrover, 2 wolseleys and austin, so i think i have the knack for it
-
- Series MM Registrar
- Posts: 10183
- Joined: Sun Jul 24, 2005 11:39 pm
- Location: Reading
- MMOC Member: No
Check for fuel delivery and spark at the plugs. Give the engine some choke and open the bonnet and pull the accelerator cable as you crank the engine. As long as there is enough battery power to light the ignition lamp then there should be enough to start the engine on the handle as all the power that was being used by the starter is available to spark the plugs.
[sig]3580[/sig]
As you say MarkyB - if it starts fine off the key normally and runs OK then the starting handle operation is purely down to technique or a failure to do one of the normal starting operations....
To start off the handle you need to turn engine until you get to the compression stroke (feel for max resistance) then give the handle a sharp "jerk" whilst keeping a loose grip on the handle to allow it to spin off the crank nut freely without ripping your wrist off....
To start off the handle you need to turn engine until you get to the compression stroke (feel for max resistance) then give the handle a sharp "jerk" whilst keeping a loose grip on the handle to allow it to spin off the crank nut freely without ripping your wrist off....

[sig]8426[/sig]
Compare the Minors - Simples !! http://mog.myfreeforum.org/index.php
Compare the Minors - Simples !! http://mog.myfreeforum.org/index.php
-
- Minor Fan
- Posts: 103
- Joined: Wed Apr 21, 2004 1:55 am
- Location: Christchurch, New Zealand
- MMOC Member: No
Agreed. I've managed to crank started my old girl when completely flat, but I still needed the help of 7.2Ahr gel cell to get her to fire.mike.perry wrote:As long as there is enough battery power to light the ignition lamp then there should be enough to start the engine on the handle as all the power that was being used by the starter is available to spark the plugs.
I don't think the fuel pump is an issue, as there's about 12 seconds worth of idling sitting in the float chamber. My guess, for what it's worth - timings out.
Regards Grant
AK7508 - Purple 1954 Series II
AK7508 - Purple 1954 Series II
I had the same problem last week, battery quite dead except for light, car wouldn't go.
I have an alternator, does the spinning alternator sap the battery of any power?
as said above, doubt it's fuel pump, there's loads of fuel in the float chamber.
Andrew
I have an alternator, does the spinning alternator sap the battery of any power?
as said above, doubt it's fuel pump, there's loads of fuel in the float chamber.
Andrew
Maggie, 1969, 4 door, Almond Green.
And Project "Traveller"...
[sig]4253[/sig]
And Project "Traveller"...
[sig]4253[/sig]
I know, that's why I changed from a dynamo as it can be a pain in winter traffic jams. But doesn't an alternator rely on battery power to power the rotor windings instead of using a permanent magnet like a dynamo?
Hence if your batter is quite dead, when the engine (and alternator) is turning on the starting handle, the alternator may soak up some battery power (where a dynamo won't) leaving less for the spark.
Just a thought, as even with a quite dead battery when I had a dynamo mine would start, whereas currently have an alternator and it won't.
Maybe I need to do a back to back test.
Andrew
Hence if your batter is quite dead, when the engine (and alternator) is turning on the starting handle, the alternator may soak up some battery power (where a dynamo won't) leaving less for the spark.
Just a thought, as even with a quite dead battery when I had a dynamo mine would start, whereas currently have an alternator and it won't.
Maybe I need to do a back to back test.

Andrew
Maggie, 1969, 4 door, Almond Green.
And Project "Traveller"...
[sig]4253[/sig]
And Project "Traveller"...
[sig]4253[/sig]
Sorry for digressing Chris
I generally turn it over a few times with the ignition off, choke out to fill each cylinder with a good charge before getting it the point of compression, "ignition on" then spin the handle, starts well like that.
Sounds like you're used to the starting drill with other cars though.
maybe the others are right and the timing is a little out? Or the ignition system isn't in tip top order?
Andrew

I generally turn it over a few times with the ignition off, choke out to fill each cylinder with a good charge before getting it the point of compression, "ignition on" then spin the handle, starts well like that.
Sounds like you're used to the starting drill with other cars though.
maybe the others are right and the timing is a little out? Or the ignition system isn't in tip top order?
Andrew
Maggie, 1969, 4 door, Almond Green.
And Project "Traveller"...
[sig]4253[/sig]
And Project "Traveller"...
[sig]4253[/sig]