Diffrential!

Post by **Naadeslaus** » Tue Oct 27, 2009 9:17 am

Will a diffrential from a 1098 fit in a 948 rear axel??

Post by **bmcecosse** » Tue Oct 27, 2009 9:20 am

Post by **Naadeslaus** » Tue Oct 27, 2009 9:23 am

Okey thanks!!

Post by **mike.perry** » Tue Oct 27, 2009 9:42 am

I keep forgetting which diff has the filler in the casing.

Post by **DAVIDMCCULLOUGH** » Tue Oct 27, 2009 3:38 pm

I stand to be corrected ( this is from memory), but if you fit a 1098 diff into a 948 casing I think there is no where to put the oil in!!! The 948 oil is put in from the front and on the 1098 its on the back.

Post by **bmcecosse** » Tue Oct 27, 2009 3:50 pm

Poster only asked if it will fit - it does! Oil can be added by removing the vent - measured quantity added - replace vent. Or - jack car at a good angle - remove uphill halfshaft - add measured quantity oil - refit half shaft etc. The half shafts will be out anyway to fit the diff.