New wheels!

Post by **Naadeslaus** » Thu May 21, 2009 2:57 pm

Finaly i have got the new wheels on my car. What do you think??

Post by **mike.perry** » Thu May 21, 2009 3:00 pm

Make sure that the tops of the front tyres don't scrape the wheel arches when cornering over rough surfaces!

Post by **Naadeslaus** » Thu May 21, 2009 3:04 pm

Yes i know Mike!

Post by **jonathon** » Thu May 21, 2009 4:33 pm

Very nice, can you have them in Ford PCD, I presume that they are 14"'s or 15"'s ? and 5.5 or 6 J ?

Post by **Naadeslaus** » Thu May 21, 2009 5:38 pm

jonathon wrote:Very nice, can you have them in Ford PCD, I presume that they are 14"'s or 15"'s ? and 5.5 or 6 J ?

This is original Minor wheels. So you don't get them in Ford PCD.

Post by **FrankM83** » Thu May 21, 2009 9:26 pm

ahhh how I likkkee!!

Post by **moggyminor16** » Thu May 21, 2009 9:52 pm

i like a lot

Post by **bmcecosse** » Thu May 21, 2009 11:07 pm

Well - they are hardly 'original Minor wheels' - have they had wider rims fitted to the Minor centres ?

Post by **Naadeslaus** » Fri May 22, 2009 8:22 am

bmcecosse wrote:Well - they are hardly 'original Minor wheels' - have they had wider rims fitted to the Minor centres ?

yes that's right cosse. But they almost original

Post by **leyther8008** » Fri May 22, 2009 12:07 pm

Outstanding! literally.

Post by **dunketh** » Fri May 22, 2009 12:29 pm

That car is now officially too cool.

Also, did you move the wheel around so 'M' could be read?

Post by **Naadeslaus** » Fri May 22, 2009 1:31 pm

dunketh wrote:That car is now officially too cool.

Also, did you move the wheel around so 'M' could be read?

Is it too cool???

No that was just pure luck!!

Post by **Mogwai** » Fri May 22, 2009 10:52 pm

Snap ?

<br>

<br>

Post by **tortron** » Fri May 22, 2009 11:29 pm

very nice,
I came across photos of your car not long after getting my morrie. It effectively sealed the deal to paint her black. Then after seeing these i have renewed enthusiasm to get back to block sanding (once the ice melts first i think

)

What donor bands were used? or were the off the shelf stock from a wheel place? I am currently using early ford falcon 13 inch steels, tho i can see the benefit of filling those guards up a bit more

Post by **Naadeslaus** » Sun May 24, 2009 5:38 pm

tortron wrote:very nice,
I came across photos of your car not long after getting my morrie. It effectively sealed the deal to paint her black. Then after seeing these i have renewed enthusiasm to get back to block sanding (once the ice melts first i think )

What donor bands were used? or were the off the shelf stock from a wheel place? I am currently using early ford falcon 13 inch steels, tho i can see the benefit of filling those guards up a bit more

I don't know what bands that is used. It's a member in Nordic Morris Minor Club that make these!!