FITTING HEAD LINER

Post by **PAULJ** » Sun Apr 12, 2009 8:41 pm

Can anyone help me with this. I have fitted the head liner and its gone ok, all square and tight, but I cant work out how the bits at the back finish. The car has never had a headlining so Im at a loss. The cable runs down the channel at the back but how does it get to the screw it ties to? Any advice photos please as I want to finish it tomorrow.
Thanks

Post by **croft** » Sun Apr 12, 2009 10:18 pm

These any good?

Post by **PAULJ** » Sun Apr 12, 2009 10:22 pm

Thanks for that but its the other bit, the side wire where it comes down the top of the side window.
Thanks

Post by **croft** » Sun Apr 12, 2009 10:49 pm

Ok then how about these?

This is on a 4 door so may be different if you have a 2 door! Would think it should be similar tho, just look for a hole somewhere near to the one on the photo. Hope I've been of some help!

Post by **PAULJ** » Mon Apr 13, 2009 4:51 pm

Thanks for that croft, The four door is different to the two. Sorted now thanks