I want to fit some capri hubs ( i have them and it looks feasable) to the minor to get a 4x108 PCD.
To do this I need to know the dimensions of the standard minor bearings, can anyone help?
I especially need to know internal dia. and the width of both front bearings so I can look up and see if there is a "standard" wheel bearing avaliable off the shelf
The best figures I can come up with are as follows-----outer front bearing 0.550 thick/wide, shaft diameter 0.668. Inner bearing ? thick/wide, shaft diameter 0.983. I measured the stub axle to get the diameters and I only had the outer bearing to get the thickness from.
Both the Minor front wheel bearings are metric series, which is why the imperial dimensions look a bit odd.
These are the two bearings:
Inner 7205B 25mm ID 52mm OD 15mm Wide
Outer 7303B 17mm ID 47mm OD 14mm Wide
They are angular contact ball bearings, and were originally 'face adjusted', which means a closer tolerance on the thickness. Most of the commonly avaliable bearings toady are not face adjusted, which is why there are problems getting them to fit as they should.
the code I gave on my earlier post was for a rear bearing ,