Gary
ignition timing
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
ignition timing
Hi can you help me again do you know what the ignition timing is on a 1098cc runing on unleaded petrol thanks
Gary
Gary
-
MoggyTech
- Minor Legend
- Posts: 1466
- Joined: Sat Aug 11, 2007 12:06 pm
- Location: Livingston Scotland
- MMOC Member: No
Static timing is 2 degrees BTDC for 25D4 distributor.
Set it to that and check for pinking under load. Advance timing till it just pinks under heavy load, then retard using little wheel on dizzy till pinking just stops.
A bit of trial and error involved of course.
If using a strobe, make sure idle below 600 RPM and disconnect the vacuum advance, and set for 6 degrees BTDC
Set it to that and check for pinking under load. Advance timing till it just pinks under heavy load, then retard using little wheel on dizzy till pinking just stops.
A bit of trial and error involved of course.
If using a strobe, make sure idle below 600 RPM and disconnect the vacuum advance, and set for 6 degrees BTDC
[img]http://i49.photobucket.com/albums/f264/Ghostrider117/sig.jpg[/img]
http://www.freewebs.com/moggytech
http://www.freewebs.com/moggytech