Computer help required

Post by **8009STEVE** » Thu Apr 10, 2008 7:45 pm

I can weld, I can spray etc but I can not get my printer to work properly. When I hit the print button, the paper comes half way out before it starts to print and I lose the bottom half of print.
Anybody got any ideas?
Thanks
Steve

Post by **rv8** » Thu Apr 10, 2008 8:20 pm

weld a longer bit of paper on

Post by **NZJLY** » Fri Apr 11, 2008 8:03 am

Is it a new problem or new printer?
If it is a new printer, it may need a new driver. If it is a new problem you may need to reset the default setting on your printer.
John

Post by **Alec** » Sat Apr 12, 2008 7:16 am

Hello Steve,

firstly go to your printer's maintenance page and do a test page. From that use the help section to correct the fault. (Hopefully

)

Alec

Post by **8009STEVE** » Sat Apr 12, 2008 4:33 pm

Ended up getting a new printer.