Halfshaft spline size ?

Post by **Spag** » Mon Jan 28, 2008 10:27 am

Hi,

Can anyone tell me the spline size on the halfshaft/diff gears ??

Ta

Post by **Kevin** » Mon Jan 28, 2008 3:54 pm

Hi Ian I have a half shaft I can check for you which dimension do you need, may be easier to send me a pm.

Post by **Spag** » Mon Jan 28, 2008 4:22 pm

Hi,

Just after the diameter of the splined bit, and the number of splines.

But if you were feeling brave and could take a photo of it end on, then that could be handy too

Thanks

Post by **Kevin** » Mon Jan 28, 2008 11:16 pm

PM sent with info as requested.

Post by **bmcecosse** » Tue Jan 29, 2008 4:14 pm

Why not share it with us all Kevin ? Stuff like that I try to note in my Manual!

Post by **Kevin** » Tue Jan 29, 2008 6:08 pm

Hi Ian I have sent it again to XXXXX and it's not bouncing.

The half shaft has 10 splines and according to my vernier the splined section is 0.983" or 24.93mm (if I am reading the metric correctly as I still work in English) hope this helps.

Post by **bmcecosse** » Tue Jan 29, 2008 6:27 pm

Thanks Kevin - duly noted.

Post by **Spag** » Tue Jan 29, 2008 10:17 pm

Thanks

Got the email this time, dunno where the other one went - not hiding in me junk or anything !

Um could you scrub me email from the message here please, spambots and all that, ta !

Post by **bigginger** » Tue Jan 29, 2008 10:21 pm

Dunnit, innit
a