when i turn of the ignition to stop the engine it couths and splutters for a second or two before stopping, i've set the timing as well as fitting new plugs points condenser and as far as i can tell the mixture is ok, other than that she starts and runs fine, any ideas what else to look at
cheers
Ignition light 'on' with an alternator will be tricky! It's designed to charge at idle. Basically - set the idle speed as slow as possible - but without it stalling when you plop foot on clutch. Try a different brand of petrol - and try advancing the ignition timing slightly - basically until you hear pinking, then retard again slightly until not quite pinking!
Indeed - but just in case (let's face it most Minors now have alternators) - I have pointed out the problem to save possibly hours of futile twiddling trying to get the light on!
Just have a quick check over your tappet clearances. I had a very similar problem with my Pickup, Timing was correct, mixture seemed right, tickover was nice just like yours and it turned I my tappets were a bit on the tight side. A slightly open valve gets hot and would cause running on. 12 thou was the BMC specification but Ive read in previous threads that wider ones are better for unleaded petrol.
thanks for the advise,
i do have an alternater, but thinking about it i just started using unleaded when the prob started so i think i'll look at the valve clearences
cheers
i've just slowed the tickover down a tad and advanced the timing to 5* tdc and it seems to have solved the problem, seems to run smoother being that little bit advanced as well
many thanks for the ideas and advise
john
Well done - I suggest you continue advancing little by little until you hear some pinking - then take it back slightly until no(or just v slight) tinkle when you put your foot down. It's then set to the optimum for your engine.