torsion bar fitting

Post by **steve4063** » Wed Jun 27, 2007 4:13 pm

right i'm ready to fit the bars now.

everything is off completely when i got it so whats the best way to tackle it?

thanks

Post by **bmcecosse** » Wed Jun 27, 2007 8:51 pm

Fit rear reaction levers to the bars and assemble loosly to the cross member. Then start at the front - sliding the suspension arm on first followed by the other parts and the T bolt - then load up the suspension and on to the other side. It's never going to be right height straight away - so don't tighten it all up just yet - it's going to need 'adjusting'.