Front bump stops

Post by **southerly95** » Fri Apr 20, 2007 11:27 pm

A previous owner has had new inner wings put in but not replaced the bump stops and there aren't any holes there. Does anyone know the precise location/measurements for these please?

Many thanks, John

Post by **simmitc** » Sun Apr 22, 2007 11:27 am

Haven't got drawings, but the best idea is to jack up each wheel in turn so that you can see where the top of the swivel pin is coming, and position the stop so that it will do its job. Note that the stops are handed, and should be stamped L/H and R/H. The fron bolt goes through a hole in a small lip on the wheel side of the inner wing, and rear one just off the curve of the inner wing to the rear of the vertical plate that runs up to the edge of the lip where the bonnet closes. Hope that makes sense.