LCV chassis building, design, ideas bouncing etc

Post by **alex_holden** » Wed Apr 04, 2007 12:04 pm

wibble_puppy wrote:(Wish I knew how to get the cavity wax on to the top of the inside of the box section, as well as the sides and the floor of it )

I should have thought a compressed air powered gun with a decent spray nozzle would coat the whole of the inside of the box section... Perhaps you could make a dummy chassis leg section from cardboard, spray it with wax, open it up, and see if it's all covered.

Post by **wibble_puppy** » Wed Apr 04, 2007 12:14 pm

alex_holden wrote: I should have thought a compressed air powered gun with a decent spray nozzle would coat the whole of the inside of the box section

Ah, of course. Well it's my MM garage doing that bit (as part of their guarantee of their work on the shell and chassis) so I'll hover and shout out "AIR!" while they work. (I'll blame it on you

)

Post by **les** » Wed Apr 04, 2007 10:07 pm

I've been reading these posts with interest, what on earth is Paul concerned about, to suddenly edit his posts like that? If we all had the same view on everything there would be no discussion and no need to share opinions.

Post by **bigginger** » Wed Apr 04, 2007 10:44 pm

I don't quite know. but I humbly apologise for any offence given on my part.

Post by **aupickup** » Thu Apr 05, 2007 6:11 pm

well we all were only trying to help, but some just dont like constructive thoughts, ah well thats life

Post by **bigginger** » Thu Apr 05, 2007 6:29 pm

Tell you what, I'll lock this now to save any more accidentally hurt feelings.