Falcon Exhausts.

[wanderinstar]

Actually the picture posted by Minorpickup is of the twinpipe setup which is listed for an Ital exhaust manifold. That one is £72. The next one down on ESM's site is a single pipe for a Marina. That one is £22.
I have an exhaust manifold from a MG Metro which is a 3-2 cast iron one, which looks identical to the Ital one. Yes Kevin the system I am talking about is large bore (1 1/2") as mentioned earlier. The system in question is made by Falcon Exhausts thats why the thread is titled "Falcon Exhausts"

Hope that clears everything up.

Getting back to the original question. Has anyone got one of these systems???

[bmcecosse]

Ah - so Marina = single outlet and Ital = twin outlet same as Metro and MG Metro!! That's cleared it up a wee bit for me.
Not been blown over in these high winds Ian ? I noticed all the 'empty' curtain side units up here are running with the curtains tied open !!

[Kevin]

Yes Kevin the system I am talking about is large bore (1 1/2") as mentioned earlier. The system in question is made by Falcon Exhausts thats why the thread is titled "Falcon Exhausts"

I know Ian, but I was responding to Bens post which was for the standard system.

[wanderinstar]

Saying nothing. Not tempting fate.

Sorry Kevin.

[Nadir]

Yes... but there is also a twin downpipe one... same configuration on the exhaust as the metro but with a cast in inlet

Not for the Marina, AFAIK

[wanderinstar]

Do I take it then from the lack of positive or negative replies that no one on this forum (apart from 2 people, who aren't too impressed with them) have fitted this type of system fitted to their vehicle.

[Peetee]

Noisy and badly made (front box and rear box sections both too long).
I have a single downpipe section and the orbital cup joint needs gum for a proper seal. Much as I'd like the twin-pipe section, the thought of trying to get two joints to seal is too nerve-wracking to contemplate!

[bmcecosse]

I agree there!!