dripping oil filter

Post by **cliff** » Thu Aug 10, 2006 11:58 pm

changed the oil and filter recently and now i have a small oil drip coming from the end of the filter retaining bolt.

i think the leak is coming through the rubber seal in the bottom of the filter outer case where the bolt goes through - is this part available?

Post by **bmcecosse** » Fri Aug 11, 2006 7:21 am

You may have to make your own. Try tightening it - slightly!

Post by **Kevin** » Fri Aug 11, 2006 9:28 am

is this part available?

Yes and there are 2 types

http://morrisminorspares.co.uk/shop/pro ... ebbc0107db

http://morrisminorspares.co.uk/shop/pro ... ebbc0107db

Post by **cliff** » Fri Aug 11, 2006 9:43 am

cheers chaps

Post by **minor_hickup** » Fri Aug 11, 2006 8:03 pm

Mine used to drip, but I packed a bit of grease behind it before re fitting and it seems to have solved it.

Post by **bmcecosse** » Fri Aug 11, 2006 8:41 pm

Box of very useful rubber washers etc in Poundland has a selection of all shapes and sizes - intended for sealing leaking taps and so on - but has many other uses. Well worth the Pound!! Very well may have something to suit - certainly worth having on the shelf for emergencies - both auto and domestic.

Post by **rayofleamington** » Fri Aug 11, 2006 8:55 pm

or for making flat rubber washers in an emergency - try an inner tube, but you'll need to get a piece that doesn't have ribs on it.

A cut up inner tube, a few pieces of gasket paper, some hose clips and a bit of steel pipe (wrapped with tape if a bigger diameter is needed) and if all else fails - some chemical metal! That would cure nearly all emergency leak problems