Morris Minor Owners Club

ok So SR convicted me to make my roller. I've the rims it will be a good training (after a first one on old steel plates) before changing the legs! SR, Do you have yet the sketch and could you post it here? Could you take a picture off the rollover? Yest a last question. I understand how the rollove...

Sensible to Cam advises i would prefer to have a rollover jig to roll the car. They are too expensive to buy and to reimport so i would be pleased to know if it's possible to do one myself.

Is it possible?
Someone did it?
How to do that? (plans, pictures... welcome!)

Scratch it is not a problem as the next work is the paintjob.

Did someone use this way? Is everyone ok with Cam or has somebody advise to do it carrefully?

i'm not going o use the special jig as i have to buy it and to import it in Belgium so it would be a lot too expensive for me. I'll use the second way

i don't know at the moment so i'm getting information. The books don't speak a lot about the way to do it...

and i don't risk to brake some parts?

i have only jacks to work under the car so to repair the leg, it will be a lot easier... But have i to put out other things than liquids, engine, gearbox and axle to do it? (wings, doors...) Risk i to damage then?
How to do that?

and to roll on the side?

to fo it i need to roll the car on his side. So i have to remove all the liquids and the battery. Need i to remove else other? (wings, door, wheel...)?

yet a question, i have Co2 for free (from a pub) is it good to weld or i have to use Ar?

repairing is permitted but not to patch them so i planned to buy the repair part and weld it

Some years ago the legs of my moggie were partially replaced. the person who did it was silly enough to cut the replacement parts to avoid a part of job. So as you could imagine the leg is rotten some centimeters after the welding and i've a whole... In Belgium we may not patch the chassis leg so th...

you're right, it wasn't a screw, it was a nut.

Little error ;)

fallen when i putted off the rocker's cap. It was a good an intersting question...

i've opened the engine and i was finally more stressed about the engine that it needed. After removing the rocker cover, i saw a missing screw on the rocker... No doubt the valve was released... I replaced a new one, changed the gaskets and everything is ok again. I was back on the road two houres l...

i wanted to do the test but i don"t have a compression tester
And the engine doen't make any strange noise.

Hello, I've got some stress with my engine las times. When the engine is hot, it's difficult to start and it tends to stop when i'm not running on high revolutions (or moving). When i'm on the road i can ride on normal speeds. And i have blue smokes... I think i'll put off the cylinder head to see t...

i should try to replace the fuse and if not faulty then try to clean the fuse box.

wich speed do you hear this?

I've got a similar noise between 55-60 mph and it was a defect earth wire

are the directions lights working?