Where can I get a GENUINE negative earth DLB105 Lucas GOLD SPORTS HIGH OUTPUT ignition coil from please?
There are lots of Lucas Sports Coils for sale but I've seen mention that a lot are cheap copies of poor quality sold using the Lucas name.
Genuine Lucas coil supplier?
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
- svenedin
- Minor Legend
- Posts: 4983
- Joined: Fri Aug 29, 2014 9:27 am
- Location: Surrey
- MMOC Member: Yes
Re: Genuine Lucas coil supplier?
There is no polarity to an ignition coil other than how it is connected up.
Distributor Doctor sells Lucas coils made in India and he says they are very well made and reliable.
https://distributordoctor.com/collectio ... s/pa12coil
Note that this has a screw in king lead connection (requires washer and acorn which the coil is supplied with) not a push fit connection.
Or, try to find an original new old stock Lucas coil. Old Intermotor coils are also good.
Other excellent new coils are those made by Pertronix especially the resin filled type that resists vibration better than oil filled. Make sure it is 3 Ohm for standard set up.
Stephen
Distributor Doctor sells Lucas coils made in India and he says they are very well made and reliable.
https://distributordoctor.com/collectio ... s/pa12coil
Note that this has a screw in king lead connection (requires washer and acorn which the coil is supplied with) not a push fit connection.
Or, try to find an original new old stock Lucas coil. Old Intermotor coils are also good.
Other excellent new coils are those made by Pertronix especially the resin filled type that resists vibration better than oil filled. Make sure it is 3 Ohm for standard set up.
Stephen
1969 1098cc Convertible “Xavier” which I have owned since 1989.
Stephen
Stephen
-
myoldjalopy
- Minor Legend
- Posts: 3567
- Joined: Tue Jan 29, 2013 10:32 pm
- Location: Kernow
- MMOC Member: Yes
Re: Genuine Lucas coil supplier?
If it is supplied by the Dizzy Doc then it is almost certain to be good.
Otherwise, autojumbles are good for old, 'proper job' coils. These go on for decades, unlike many modern imitations. I have never had a coil failure in over 40 years of continuous Minor driving, encompassing four different cars and coils. All old 'proper job' ones. Concerning ignition system failures, the old adage "Its never the coil", coined by a previous, prolific poster on here, was always made with the caveat that it did not apply to the poor quality modern imitation types.
Otherwise, autojumbles are good for old, 'proper job' coils. These go on for decades, unlike many modern imitations. I have never had a coil failure in over 40 years of continuous Minor driving, encompassing four different cars and coils. All old 'proper job' ones. Concerning ignition system failures, the old adage "Its never the coil", coined by a previous, prolific poster on here, was always made with the caveat that it did not apply to the poor quality modern imitation types.
-
Horacetoo
- Minor Friendly
- Posts: 11
- Joined: Tue Feb 03, 2026 3:07 pm
- Location: UK - Derbyshire
- MMOC Member: Yes
Re: Genuine Lucas coil supplier?
Sounds like I'm best sticking with the unknown coil that has been in the car since 1988 then!
Re: Genuine Lucas coil supplier?
Definitely, and look out for genuine old coils to carry for spares.
-
oliver90owner
- Minor Legend
- Posts: 1921
- Joined: Thu May 12, 2016 6:33 am
- MMOC Member: No
Re: Genuine Lucas coil supplier?
They all an be easily destroyed - even the good ones. A three Ohm coil takes four Amps @ 12V. The coil operational current is far less than this (points are only closed part of the time and the current rise, at switch on, is retarded by induction. If a coil is left energised without the engine running it could be consuming as much as 50W, which will destroy the coil by over-heating given enough time.
-
myoldjalopy
- Minor Legend
- Posts: 3567
- Joined: Tue Jan 29, 2013 10:32 pm
- Location: Kernow
- MMOC Member: Yes
Re: Genuine Lucas coil supplier?
Another way to easily destroy a coil, good or bad, is with a hefty lump hammer......
The fact that a coil can be damaged or destroyed is not a reason not to buy a good one.
The fact that a coil can be damaged or destroyed is not a reason not to buy a good one.
