Hi all.
I have a 1958 two door saloon Minor 1000.
I would like to adjust the front suspension down not too much, just enough to give it the look I want.
I know it has torsion bar set up, but I have never worked on torsion bars.
I have followed the manual before looking at the car, hopefully over this weekend if the weather holds as I have to work outside on it.
Any helpful tips, and on reassembly being a torsion bar is this hard to get back into place, as I guess from the name, that it may be under tension as I'm trying to put it back?
Also can this be done on my own easily enough
I hope this makes sense, very amateur questions I'm guessing but hopefully get some informative answers.
All the best
Front suspension lowering
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Newbie
- Posts: 2
- Joined: Fri Aug 11, 2023 3:59 pm
- Location: Redditch UK
- MMOC Member: Yes
Re: Front suspension lowering
If all is in good condition, then It is a simple one person job. Lack of maintenance, rust and old underseal may cause problems. Follow basic safety advice and the instructions in the manual and you should be OK. Whilst you have everything stripped down, you should consider renewing the rubber bushes - most folk have swapped to poly ones.
-
- Newbie
- Posts: 2
- Joined: Fri Aug 11, 2023 3:59 pm
- Location: Redditch UK
- MMOC Member: Yes
Re: Front suspension lowering
Thank you.
Is it easy enough to put back together or will it be under tension?
That's my main concern.
Sorry for all the questions.
Thank you again
Is it easy enough to put back together or will it be under tension?
That's my main concern.
Sorry for all the questions.
Thank you again
-
- Minor Legend
- Posts: 1668
- Joined: Thu May 12, 2016 6:33 am
- MMOC Member: No
Re: Front suspension lowering
If you want to lower it below factory specs, I would suggest fitting smaller diameter wheels.
- svenedin
- Minor Legend
- Posts: 1944
- Joined: Fri Aug 29, 2014 9:27 am
- Location: Surrey
- MMOC Member: Yes
Re: Front suspension lowering
To reassemble yes there will be some tension. You support the lower suspension arm on a jack (as well as having the front of the car supported on axle stands and blocks of wood on the chassis rails. You must be careful not to lower too far or the dampers arms will smash the bump stops and inner wing. Personally I wouldn’t do it.Redditch-Minor wrote: ↑Fri Aug 11, 2023 10:01 pm Thank you.
Is it easy enough to put back together or will it be under tension?
That's my main concern.
Sorry for all the questions.
Thank you again
Stephen
1969 1098cc Convertible “Xavier” which I have owned since 1989.
Stephen
Stephen